2015 Southern Raceway Stinger Rules
If you currently drive in another class other than Stinger, or have driven full time in the past two years in another class, you are not allowed to race in this class.
Bodies & Frames
1. Any make or model front wheel drive 4-cylinder only. NO EXCEPTIONS
2. May run all-wheel-drive/4-wheel-drive cars if rear drive shaft is removed. NO EXCEPTIONS. Car must pull with front wheels only. This will be checked before the race begins.
3. May be 2 or 4 door; hatch back, sedan, station wagon, etc.
4. No turbo or supercharged cars allowed
5. No NOS or other performance enhancing devices allowed.
6. All glass must be removed. Including lights.
7. Remove all burnable upholstery
8. May replace stock dash with sheet metal dash
9. All exterior chrome and molding or anything that can come off the car must be removed.
10. Battery must be put in fully enclosed battery box, securely mounted to car
11. Remove the insulation under the hood.
12. Must have 20" number on each side and 20" number on roof of car for scoring.
13. External parts may be removed such as A/C compressor and dehydrator, PS pump, etc… Absolutely no performance parts may be added to the engine with the exception of spark plugs and air filters. Air filters MUST utilize STOCK air box.
14. All ECM's (computers), including chips, MUST be OEM Stock for year, make and model of car. All computors and ECM's must be securely mounted behind dash out of reach of driverAbsolutely NO aftermarket performance chips or computer modifications!
15. All cars MUST have stock bumpers front and back. Damaged body parts may be covered with sheetmetal or plastic provided original body remains underneath repaired areas where possible.
16. All cars must have tow chains front and back
1. Must have serviceable fire extinguisher SECURLY mounted within reach of driver, no tape or zip ties.
2. Must have window net on driver's side with proper mounting hardware.
3. All cars must have a minimum of a 4-point roll cage with a minimum of 3 driver side door bars. Must use minimum 1/8" steelplate over all 3 drivers door bars
4. Must use 4 or 5-point safety harness. Harness must be bolted to roll cage , all belts to be less than 5 yrs old and all frayed belts must br replaced.....NO EXCEPTIONS
5. Must use approved racing seat bolted to roll cage.
6. Gas tank may be replaced with a fuel cell, but must remain "centered" in the trunk area, no offset to either side.
7. If gas tank is behind rear axle, then you must install a "U" shaped bar between rear bumper and tank.
8. All cars must have 3 windshield bars 3/8" in diameter, securely welded to roll cage
9. Recommend screening of window at least in front of driver
10. All roll cage areas that the driver may contact during race conditions must be covered with padding.
11. May install quick release steering wheel for safety considerations however steering column must remain stock.
12. Master Battery disconnect switch must be used and located so that the driver or EME. personnel can get to it. ( RED HANDLE )
13. All cars must pass saftey inspection or no racing that event, or until issue is fixed
1. All springs/struts must be stock height, size, and rate.
2. OEM type passenger car shocks only. No air shocks. No racing shocks.
3. Stock Bump Stops on suspension.
4. All steering components must remain stock.
5. All wheels must remain straight up and down with no adjustment in camber
6. No strut supports of any kind...NO EXCEPTIONS
Tires and Wheels
1. Must be Factory Stock or steel OEM or equivalent wheels, NO RACING WHEELS
2. No mud tires, DOT street tread only.
3. Tires do not have to match each other in size or brand.
4. Wheel size must be factory (if car came with 13" wheels, then you must run 13" all the way around. 14" must run 14", and so on. Cannot run other than stock offset on wheels and cannot run wider than stock wheels.
5. No tire soaking/and or treating in any class. Any driver/owner/crew member found to have used, or brought, any tire soaking chemicals onto SRW property will be asked to leave the property and will be subject to fine and or suspension.
Transmission & Driveline
1. Automatic or manual
2. If car came from the factory with an automatic transmission, you must use an automatic transmission. If it came with a manual, then you must use a manual.
1. Engine must be a 4-cylinder only for year, make, and model of car. Cannot interchange engines.
2. If it came with a carb, then you must have a factory carb. No modifications allowed.
3. If it came fuel injected, then must be fuel injected.
4. Carb must be for year, make, and model.
5. Cannot change any internal or external engine parts other than factory stock or factory replacement parts.
6. Absolutely NO turbo or superchargers allowed!
Check Us Out On
Highway 90 in Milton, FL
S & W Containers
Wes Paul Auto Glass
USA Performance Center
Sessions Construction Services
Olivers Landscape and Nursey
Psychotic Tattoo Studio